Rod Bacon wrote:
I am wanting to front-end a legacy PBX with an asterisk box. I have done
plenty of asterisk work over the last 6 months to PRI circuits, but not
with a PBX being involved.
I know I can use asterisk and digium cards in this manner, but do I need
separate cards for the PRI -> Asterisk side to the Asterisk -> PBX side,
or will a 4-port PRI card do the job? (I already have a spare one of
these).
Short -- yes, can be done.
We just did one install with two incoming E1s connected to ports 1 and 2 on a
Sangoma A104, and ports 3 and 4 were outgoing to an Avaya PABX.
In other words, can I use SPAN 1 as a timing source, then provide timing
to the PBX connected to SPAN 2 of the same card?
That should do it. You'd just need to configure zaptel.conf properly. There's an
example somewhere on the Wiki about integrating Asterisk with legacy systems.
Cheers,
Flynn
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
