On Friday 09 of September 2005 19:04, Mojo with Horan & Company, LLC wrote: > Did you try to get a milliWatt test phone number from your telco? It > was really easy for me. I called the business office and told them that Well, unfortunately not everyone has similiarly helpful telco providers ;) To just give you a hint, ten years ago here when you applied for a phone line you would have to wait about 3-7 YEARS to actually have it installed. Its improving now, but even now if the line is dead it takes them up to a few days to repair it ;) try not to laugh :) I'm pretty sure if i'd call them to ask for a balancing line they would probably assumed it an abuse ... Seriously however, even if i could get some reference signal, how can i tune the card apart from changing the rx/tx gain? even with these two down to -6.0 dB i'm still getting awful lot of echo ... The card is a simple X100P clone.
The only piece i have not yet tampered with is the load the card places towards the PSTN line. The card's input circuits are all SMD - no old-fashioned (but good) separation with a transformer :( I'm thinking about playing around with increasing/decreasing resistance by placing additional resistors in the circut. Messy, but if it could help... What do you think? Marek _______________________________________________ --Bandwidth and Colocation sponsored by Easynews.com -- Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
