Some ISO firmwares have bugs.. we ran into this and had to downgrade to get it to work correctly.
bkw On Fri, 26 Sep 2003, Bartosz Jozwiak wrote: > I have fixed i already. > And still it does not want to work :( > > > ----- Original Message ----- > From: "Sean Figgins" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Friday, September 26, 2003 11:58 AM > Subject: Re: [Asterisk-Users] Cisco 2600 and ASTERISK > > > > On Fri, 26 Sep 2003, Bartosz Jozwiak wrote: > > > > > I have pointed it to Asterisk for sure not to local cisco ethernet. > > > I think there is something wrong with the router. > > > > In the exerpt from the config you posted (below), the destination in the > > dial-peer is the same as the address on the enternet interface. Perhaps > > this is not your actual config? > > > > In any event, if this is correct, it should work. > > > > > > > dial-peer voice 1000 voip > > > > > max-conn 4 > > > > > destination-pattern 9999 > > > > > req-qos guaranteed-delay > > > > > codec g711ulaw > > > > > ip precedence 5 > > > > > no vad > > > > > session target ipv4:66.178.37.169 > > > > > ! > > > > > ! > > > > > interface Ethernet0/0 > > > > > ip address 66.178.37.169 255.255.254.0 > > > > > no ip directed-broadcast > > > > > half-duplex > > > > _______________________________________________ > > Asterisk-Users mailing list > > [EMAIL PROTECTED] > > http://lists.digium.com/mailman/listinfo/asterisk-users > > > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
