In my case it's not MWI (I didn't have it enabled - 0 splash), also had most
Supplementary services turned off. The rings are actually generated from the
FXO side of the spa, presenting to Asterisk as an incoming call.
Mine is likely to be a power issue, I experience frequent quick power "events"
(incandescent lights flickering) here etc. It's also on a UPS with surge
suppression (APC SmartUPS 1000VA), but that seems limited to "oops, power is too
high/low better go onto battery now", so small/quick events would likely pass
through it.
I've just upgraded and will reconnect to Asterisk now, so I'll know in a few
days if it's done the trick; if not, my lovely wife will certainly let me know :)
BJ Weschke wrote:
That's what I had thought originally too, but apparently there is/was
an issue with the 3.1.5gw and below firmware where it was possible for
AC noise coming from the power supply to be falsely identified as a
ring. Sipura has apparently just released 3.1.7 to deal with this.
I've never had this particular problem I think because I have the
spa3k's here on an online UPS, but doing a bit more reading, Paul is
certainly not alone with what he's been experiencing.
On 10/3/05, *Damon Estep* <[EMAIL PROTECTED]
<mailto:[EMAIL PROTECTED]>> wrote:
I am jumping into this thread late, so forgive me if I missed relevant
info, but the single ring you hear is more than likely the "MWI Splash"
which can be disabled by simply setting the duration of the splash to 0
seconds.
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
