Hi all,
I have a shed load of UK (BT) analogue equipment at our office (18
phones, 6 faxes) hooked up via structured cabling to an old Avaya
ArgentOffice phone system. The on-its-way-out phone system has an
IDSN30e PRI interface talking to the BT exchange delivering 18 channels.
If I were to buy a 2 port PRI card like the TE205P would this allow me
to put asterisk in between?
BT.EXCH <===> ASTERISK <===> Avaya PBX <===> Tphones/fax
||
IP-Phones :-)
My objective is to allow the introduction of IP phones at remote sites
using an existing OpenVPN tunnels, and start the migration to new kit.
I would reset the Avaya config to present its POT's FXS sockets as
single channels on the IDSN and then do the extension routing and call
handling with asterisk.
Questions:
o Can Asterisk inpersonate a telco over IDSN 30e well enough to please a
PBX?
o .. with pass-through CLID?
o Avaya PBX has some very old VOIP support, so does anyone know if the
ASTERISK <===> Avaya link may be possible over IP?
o Has anyone seen this working?
Kind regards, and thanks for any thoughts you may share.
Chris
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
