I am connected to Cox Cable telephone service which nicely passes CID when using an X100P card but am not getting CID when using the SPA3000. I am using 3.1.5(GWb) -Kerry
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Wednesday, October 26, 2005 9:57 AM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: Re: [Asterisk-Users] SPA3000 as trunk - no caller ID What are you plugging into the FXO port? I have two SPA-2000's. One is connected to an SBC POTS line and the other to a Vonage Cisco ATA186. The SPA3k connected to the SBC POTS passes CID info, the one connected to the Cisco ATA will not. I have tried many things mentioned at AAH SF.net site and Voxilla's forums (and probably a few others) and was never able to get it to pass the CID info. According to the Samurize program and the SPA3k web page, the SPA3k is receiving the CID info from the Cisco ATA. I gave up and now I have my Vonage line forward all calls to my Teliax account. I'm running 3.1.3(GWa) on both units. At 09:37 AM 10/26/2005, you wrote: >Following the instructions at http://geekgazette.com, I have the >SPA-3000 setup as a SIP trunk. This is working flawlessly with one >exception, it isn't passing caller ID. Regardless of what settings I >have tried, I can't seem to figure this out. Has anyone else got it to work? >-Kerry _______________________________________________ --Bandwidth and Colocation sponsored by Easynews.com -- Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ --Bandwidth and Colocation sponsored by Easynews.com -- Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
