Hi all,
I currently have this configuration.
exten => _X.,1,Dial(SIP/${EXTEN:[EMAIL PROTECTED]:5060)
exten => _X.,102,Set(PRI_CAUSE=42)
exten => _X.,103,Hangup()
I have an Asterisk box connected via E1/PRI to Siemens PBX. The siemens
PBX sends my Asterisk box all cell phone call, and from the Asterisk box
I dial SIP to a SIM gateway. I am trying to implement a fail-over, as
in where the sims are not working, etc, then I send a PRI_CAUSE back to
the PBX. However, this works in some cases, i.e. when I get a 'No
circuit available' - 503 Service unavailable then it goes to the 102
priority. But it does not go to the 102 priority on ' 488 Not
Acceptable Here' .
So my question is how to I make it go to priority 102 whenever it fails
in priority 1
Any ideas??
thanks
yusuf
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
