Hello,
Ever since I started playing with Beta versions of Asterisk, I've had a
problem. It might just be coincidence though, since before that I didn't
touch the Asterisk PC for a good 2 weeks and I had done alot playing around
with config files.
I have a 4 port FXS/FXO card (with 2 of each in). I asked in this mailing
list about an Audio pipe broken (error message from Asteirsk) and I was told
it was usually Zapata.conf that was the problem, and I confirmed it was.
The problem si I don't know what the exact cause is.
I have my channels defined in zaptel.conf as
fxoks=1,2
fxsks=3,4
In zapata.conf, I have: (I commented out the other 2 cards)
signalling = fxo_ks
context = test
channel => 1
signalling = fxo_ks
context = test
channel => 2
Now, this gives me the Audio pipe broken error. BUT, If I comment out
channel 1 out of zapata.conf, my second phone (connected to channel 2) works
perfectly (as far as I can tell, the dialplan works).
Further investigation showed that my var/log/messages had the following two
lines in reference to those cards:
Module 0: FAILED FXS (FCC)
Module 1: INSTALLED -- AUTO FXS/DPO
But ztcfg -vvvvvvvvvvvvv shows no error.
Am I dealing with a hardware issue? Can I fix it, or is this a defective
card?
This was seen on v-1-2-0Beta1 but I have just confirmed the same behavior on
beta2.
Thanks for any help that may come my way.
Mike
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
