Check http://www.voip-info.org/wiki-Asterisk+Paging+and+Intercom
>From that article: There is an 'allpage.agi' now available at http://aussievoip.com.au/allpage.agi. Documentation is available in the file. This should work with Snom and Grandstream GXP2000 phones (and possibly budgettones if they roll the changes across) with firmware greater than 1.0.13 (not publically available at time of writing, due out in October 2005) I've used that with my GXP-2000, and seems to work ok. I had, however, to adapt it to my needs. Regards Julian J. M. On 12/17/05, William M. Sandiford <[EMAIL PROTECTED]> wrote: > > Has anyone been successful getting Auto-Answer by Call-Info to work with the > GXP 2000 > > I have followed the suggestions in > > http://www.voip-info.org/wiki/view/GXP-2000 > > Specifically I have: > > 1. Upgraded to 1.0.1.13, which supposedly supports this feature > 2. Set Allow Auto-Answer by Call-Info to YES in the GXP2000 config > 3. Used, SIPAddHeader(Call Info: answer-after=0) in my dialplan prior to > the Dial command. > > Still the phone just rings, and doesn't auto-answer. > > Any suggestions? > > Thanks in advance, > Bill > _______________________________________________ > --Bandwidth and Colocation provided by Easynews.com -- > > Asterisk-Users mailing list > To UNSUBSCRIBE or update options visit: > > http://lists.digium.com/mailman/listinfo/asterisk-users > > > _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
