Andrew Kohlsmith wrote:
Tell the Channel Banks clock to the line, and have the Sangoma card NOT sync
to anything (i.e. the A104 is the master, the channel banks the slaves).
I set the card up so that
Port1
TE_CLOCK= MASTER
TE_REF_CLOCK= 0
Port2
TE_CLOCK = NORMAL
TE_REF_CLOCK = 1
which should make Port 2 take it's timing from Port 1 and Port 1 take
it's timing from the onboard clock.
Basically clocking works this way: Each end of a T1 sends data generated by
an on-board clock. These two clocks (one at each side) needs to be in
perfect sync with each other or you get frame slips and other nasties. The
solution is to have one of these clocks lock or synchronize to the far side.
This is know by several names, among them "line clock", "recovered clock",
"slave clock", etc. The side that is not trying to synchronize is also known
my several names... "master clock", "internal clock", etc.
On the 600 I set it to Timing = Network, but on the 750 I can't figure
out which one of these it should be.
LOOP
LOCAL
EXTERNAL
On the 600, the manual says:
"The selected clock option always designates the clock source for
transmission. Clocking necessary for receiving data is always recovered
from incoming data."
I think the 600 manual also gives me the answer for the 750:
Network Timing - The network is the source of timing. The received data
clocking is looped back to the network, where it is used to determine
the transmission timing. This option is also referred to as loop timed
as the transmission clock is derived from the received clock.
So for the 750, loop would be the same thing.
So, as far as I can tell, everything is set correctly. Which is a
problem because it does not sound right.
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
