Francesco Peeters (Asterisk) wrote: > On Wed, January 11, 2006 19:35, Stephen Bosch said: > >>I'm running Asterisk on a Gentoo box with the Zaptel 1.2.1 drivers. >> >>If I boot the machine without having the wcfxs module autoload, then >>install the module with modprobe, asterisk works just fine. >> >>If I boot the machine and autoload the wcfxs module, the module loads >>fine: >> >> >>>Jan 11 11:06:55 asterisk Zapata Telephony Interface Registered on major >>>196 >>>Jan 11 11:06:55 asterisk ACPI: PCI Interrupt Link [LNKC] enabled at IRQ >>>10 >>>Jan 11 11:06:55 asterisk PCI: setting IRQ 10 as level-triggered >>>Jan 11 11:06:55 asterisk ACPI: PCI Interrupt 0000:00:0a.0[A] -> Link >>>[LNKC] -> GSI 10 (level, low) -> IRQ 10 >>>Jan 11 11:06:55 asterisk Freshmaker version: 73 >>>Jan 11 11:06:55 asterisk Freshmaker passed register test >>>Jan 11 11:06:55 asterisk Module 0: Installed -- AUTO FXS/DPO >>>Jan 11 11:06:55 asterisk Module 1: Not installed >>>Jan 11 11:06:55 asterisk Module 2: Not installed >>>Jan 11 11:06:55 asterisk Module 3: Installed -- AUTO FXO (FCC mode) >>>Jan 11 11:06:55 asterisk Found a Wildcard TDM: Wildcard TDM400P REV I (2 >>>modules) >> >>The module is running: >> >> >>>asterisk sfbosch # lsmod >>>Module Size Used by >>>wctdm 39936 - >>>zaptel 226756 - >>>asterisk sfbosch # >> >>But Asterisk behaves as though it were not: >> >> >>> [chan_zap.so] => (Zapata Telephony w/PRI) >>> == Parsing '/etc/asterisk/zapata.conf': Found >>>Jan 11 11:32:53 WARNING[5778]: chan_zap.c:920 zt_open: Unable to specify >>>channel 1: No such device or address >>>Jan 11 11:32:53 ERROR[5778]: chan_zap.c:6847 mkintf: Unable to open >>>channel 1: No such device or address >>>here = 0, tmp->channel = 1, channel = 1 >>>Jan 11 11:32:53 ERROR[5778]: chan_zap.c:10251 setup_zap: Unable to >>>register channel '1' >>>Jan 11 11:32:53 WARNING[5778]: loader.c:414 __load_resource: >>>chan_zap.so: load_module failed, returning -1 >>>Jan 11 11:32:53 WARNING[5778]: loader.c:554 load_modules: Loading module >>>chan_zap.so failed! >>>Warning, flexible rate not heavily tested! >>>asterisk sfbosch # Ouch ... error while writing audio data: : Broken >>>pipe >> >>Looking at this now as I write this, it seems that some module >>dependencies aren't loading, but I can't be sure. Does anybody have an >>idea what's going on here? >> >>-Stephen- > > > Try running ztcfg -vvv
Yes, that fixes it -- my question, I guess, is how to get that to run automatically at boot time... -s _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
