You could try removing the asterisk config, and zaptel config from boot. and just placing it in the /etc/rc.local file
i did this for a while modprobe zaptel modprobe wcfxo..... etc etc... sleep 2 /usr/sbin/asterisk & > Yes, > > I did exactly that, but when I boot zaptel doesn't load wct1xxp. Then > asterisk dies with error code 1. > > But if I stop the service zaptel, and start it again, then zaptel loads > wct1xxp, and everything works fine. > > Then as I said, I don't get why zaptel doesn't load wct1xxp when boots. > > Regards, > > Carlos Alperin > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Ben Higley > Sent: Tuesday, January 17, 2006 9:33 PM > To: Asterisk Users Mailing List - Non-Commercial Discussion > Subject: Re: [Asterisk-Users] loading zaptel drivers automatically upon > reboot > > I have always just used "make config".. > > then edit /etc/sysconfig/zaptel to comment out the modules that i dont > need. > > >> On Sat, Jan 14, 2006 at 03:55:50PM -0500, Carlos Alperin wrote: >>> After install everything on the supposedly right place, my conclusion >>> is >>> that zaptel doesn't load wct1xxp module. >> >> That's easy to test: before you restart zaptel, look at /proc/zaptel . >> if /proc/zaptel exists, zaptel was loaded . if /proc/zaptel/1 exists and >> reports those 24 channels, then wct1xxp has loaded and identified your >> card. >> >> Another possible reason: make sure that the zaptel init.d script runs >> before the asterisk one. It needs to have a lower "start" number. Use >> 'chkconfig --list asterisk' and 'chkconfig --list zaptel' to verify >> that. >> >>> >>> Then, that is the reason for Asterisk to fail loading. >>> >>> However I change the MODULES & RMODULES on the zaptel on /etc/init.d & >>> /etc/sysconfig, it continuous same way. >>> >>> Carlos Alperin >>> >>> -----Original Message----- >>> From: [EMAIL PROTECTED] >>> [mailto:[EMAIL PROTECTED] On Behalf Of Tzafrir >>> Cohen >>> Sent: Saturday, January 14, 2006 2:36 PM >>> To: asterisk-users@lists.digium.com >>> Subject: Re: [Asterisk-Users] loading zaptel drivers automatically upon >>> reboot >>> >>> On Fri, Jan 13, 2006 at 09:39:09PM -0500, Carlos Alperin wrote: >>> > That is right for zaptel. But you still has to do modprobe wctdm on >>> rc.local >>> > before to load asterisk. >>> >>> rc.local is run after the standard init.d scripts. Thus if you load >>> asterisk in an init.d script, you'd be loading the zaptel modules too >>> late. >>> >>> Just add another init.d script. See the skeleton in /etc/init.d >>> (there's >>> a README there IIRC). >>> >>> -- >>> Tzafrir Cohen | [EMAIL PROTECTED] | VIM is >>> http://tzafrir.org.il | | a Mutt's >>> [EMAIL PROTECTED] | | best >>> ICQ# 16849755 | | friend >>> >>> _______________________________________________ >>> --Bandwidth and Colocation provided by Easynews.com -- >>> >>> Asterisk-Users mailing list >>> To UNSUBSCRIBE or update options visit: >>> http://lists.digium.com/mailman/listinfo/asterisk-users >>> >>> _______________________________________________ >>> --Bandwidth and Colocation provided by Easynews.com -- >>> >>> Asterisk-Users mailing list >>> To UNSUBSCRIBE or update options visit: >>> http://lists.digium.com/mailman/listinfo/asterisk-users >> >> -- >> Tzafrir Cohen | [EMAIL PROTECTED] | VIM is >> http://tzafrir.org.il | | a Mutt's >> [EMAIL PROTECTED] | | best >> ICQ# 16849755 | | friend >> >> _______________________________________________ >> --Bandwidth and Colocation provided by Easynews.com -- >> >> Asterisk-Users mailing list >> To UNSUBSCRIBE or update options visit: >> http://lists.digium.com/mailman/listinfo/asterisk-users >> > > > _______________________________________________ > --Bandwidth and Colocation provided by Easynews.com -- > > Asterisk-Users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > > _______________________________________________ > --Bandwidth and Colocation provided by Easynews.com -- > > Asterisk-Users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users