On 1/20/06, Marnus van Niekerk <[EMAIL PROTECTED]> wrote: > Hi, > > this is probably a stupid question but can someone point me to where I can > find the pinouts for the connector at the back of the TDM2400P card from > Digium. > > I am assuming this is some kind of telecomms standard but I need to connect > to 8 existing analogue lines and therefor need to wire this connector to a > patch panel or R11 jacks. > > Also most of the docs do not mention this card - am I correct in assuming > that I have to load the wct24xxp kernel module? and which channels will it > be for two quad fxo modules 1-8 or 13-20? >
There's an adapter on VoIPSupply that has the cable that plugs into these cards and breaks it out into RJ11 jacks for you. Otherwise, you can just get a telco cat3 AMP cable and a 66 block. Yes, you need to load the wct24xxp module, and if your two modules are to the right of the card, 17-24 will be the assignment. BJ -- Bird's The Word Technologies, Inc. http://www.btwtech.com/ _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
