Re: [Asterisk-Users] * point to point t1 solution?

[Adrian Carter]

Damon,     I am not intimately familiar with what you are specifically trying to achieve, *BUT*, if the two Norstars are essentially just 'interconnected' via teh T1 to provide either an E&M Wink "type" connection/private TDM bus between the two boxes so that extensions are 'bridged' between the two PABX's.. then *YES*.. Asterisk can do that.     I have a setup at present of an Asterisk box that has 1 E1 PRI coming in from a telco, and 1 E1 PRI going TO an Ericsson BP250 system. The Asterisk box transparently passes incoming calls destined for the BP250 to the BP250, and all the BP250 users can 'direct-dial' so to speak Asterisk extensions and vice-versa.     Since your original question is a tad ambigious to someone not entirely intimate with your setup, I could have missed the point entirely, as there is quite a few 'ways' to tie PABX's together and the reasoning can be very different (Could be for 'switched' extensions, could be for LCR setup, could be for VoiceMail integration, could be cause thats what the original installer just did...)     Hope that helps you a little. I'd suggest looking at "Connecting Asterisk to Legacy PABX's" and then extrapolate that information to suit your needs. Regards Adrian Damon Estep wrote: Jean-Michel, You missed the entire point - the question is IS ASTERISK CAPABLE OF EMULATING A POINT TO POINT T1 BETWEEN 2 BOXES, AND IF SO ARE THERE ANY WEB BASED HINTS I MIGHT LOOK AT? Not WILL YOU DO IT FOR ME? Your response to this post was un-informative and quite frankly it is the type of useless response that most mailing lists and newsgroups could do without. Damon -----Original Message----- From: [EMAIL PROTECTED] [mailto:asterisk-users- [EMAIL PROTECTED]] On Behalf Of Jean-Michel Hiver Sent: Thursday, January 26, 2006 1:36 AM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: Re: [Asterisk-Users] * point to point t1 solution? Damon Estep a écrit : Can anyone point me to a reference or sample config for bypassing a nailed up (point to point) t1 between two PBXs with asterisk and a pair of t1 cards? Right now I have 2 Nortel norstars connected to each other via a leased line t1. I also have a solid 10mbps low latency microwave link between the 2 sites. You probably need a couple of T1 cards, and some paid consulting to get it working (I've never done it myself but that's how I would do it if I was in a hurry) My goal is to run an asterisk box at each end with a t1 card and Ethernet card to act as a TDM<>SIP gateway to bypass the nailed T1 in a relatively dumb configuration, with the goal of migrating off of the norstars eventually. If it's a point to point Asterisk <-> Asterisk configuration, why use SIP rather than IAX? IAX configuration is very easy, so once you get the norstar <-> asterisk link up it'll be a piece of cake. Cheers, Jean-Michel. -- Jean-Michel Hiver - http://ykoz.net/ Découvrez la Réunion des Technologies IP & Telecom TEL: +262 (0)262 55 03 98 - RCS 434 273 330 SAINT PIERRE _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users -- Adrian Carter Technical Manager Leading Edge Internet Web http://www.lei.net.au http://support.lei.net.au Direct +61 2 6163 6162 Support 1 300 662 415 E-mail [EMAIL PROTECTED] -- Adrian Carter Technical Manager Leading Edge Internet Web http://www.lei.net.au http://support.lei.net.au Direct +61 2 6163 6162 Support 1 300 662 415 E-mail [EMAIL PROTECTED]

_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --

Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users