On Fri, January 27, 2006 17:23, Ian Cowley said:
> Iax.conf
>
> [general]
> ;bindport = 4569 ; Port to bind to (IAX is 4569)
> bindport = 5036 ; Port to bind to (IAX is 4569)
> bindaddr = 0.0.0.0 ; Address to bind to (all addresses on machine)
> disallow=all
> allow=g729 ; 4 simultaneous allowed
> allow ilbc ; prefered for iax2
> allow=gsm ; 13 Kbps (full rate), 20ms frame size
> allow=ulaw ;(g711)64 Kbps, sample-based
> allow=alaw ;(g711)64 Kbps, sample-based
> mailboxdetail=yes
> jitterbuffer=yes
>
> context=from-internal
>
> #include iax_additional.conf
> #include iax_custom.conf
>
> iax_additional.conf
> [1055]
> username=1055
> type=friend
> secret=#####################
> record_out=Adhoc
> record_in=Adhoc
> qualify=yes
> port=4569
> notransfer=yes
> [EMAIL PROTECTED]
> host=dynamic
> context=from-internal
> callerid=device <1055>
>
> Regards
> ianC
>
>
Looks like you are using AMP / [EMAIL PROTECTED]
As far as I can tell, this should work correctly... There might be
something going on in the translation by the Checkpoint NAT control...
Have you tried iax2 debug to see what it is receiving? the first few
packets should give you sufficient information...
Good luck!
--
F Peeters
PIII 450 - 1 GB - * 1.2 - BRIstuff 0.3.0 Pre 1 - Florz patch
2 Sweex HFC-PCI modes=2 sync_slave=2 timer_card=0
Cologne HFC-S pins #52, #54, #55 connected in parallel for synching.
AMD Duron 1GHz - 1GB - * 1.2.1
2 Sweex HFC-PCI cards
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
