[EMAIL PROTECTED] wrote:
Hi,
I've just compiled asterisk and get errors when trying to run it. Am I
right in thinking that if my digium card is not plugged into our ISDN
line then this is normal. If I replace zapata.conf with a blank zapata
file asterisk runs fine. The reason I ask is we don't yet have ISDN
installed in our new premises but I have to configure asterisk before we
go in.
The errors I see are:
WARNING[3227]: chan_zap.c:923 zt_open: Unable to specify channel 1:
Device or resource busy
ERROR[3227]: chan_zap.c:6879 mkintf: Unable to open channel 1: Device or
resource busy
ERROR[3227]: chan_zap.c:10311 setup_zap: Unable to register channel '1-8'
etc ...
Thanks in advance.
Phil.
Hi Phil,
No, the line does not have to be plugged in, the card just has to be
setup correctly for asterisk to see it.
after you compiled zaptel and asterisk you need to do
modprobe zaptel
modprobe wcxxxx (whichever card you have)
ztcfg -vv
this is assuming you have setup zaptel and zapata
or you could do a 'make config' in zaptel folder, then restart pc, it
would modprobe for you. 'lsmod' would show what is loaded.
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
