I'm hooked up to a regular analog POTS line. I've tried both loop start
and ground start, but no luck either way. Any other thoughts?
Thanks,
James
Doug Lytle wrote:
[EMAIL PROTECTED] wrote:
So, I'm still having this problem with outbound calls not working
when using a channel bank. I've purchased a Rhino FXO channel bank
from VoIPSupply.com to make sure it wasn't an equipment problem. I
am using a Digium TE411P card, and have simplified it down to just 1
port plugged into the channel bank, with just 1 analog line plugged
in. If I place an inbound call on the line, it goes through just
fine. However, if I attempt an outbound call, I get "Your call did
not go through. Please try your call again." After much
experimenting, I found out this happens if you
James,
When I have problems with outbound on my Adit 600, it's usually
because I have signaling screwed up on that channel. (i.e. trying to
grab a groundstart line with loopstart signaling).
Doug
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
