I used yum to install speex (although you could quite easily build your own from source).
# yum install speex # yum install speex-devel # cd /usr/src/asterisk # make clean # make # service asterisk stop # make install # service asterisk start This sequence of commands may require variation depending on your flavour of Linux and how your asterisk is installed. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Jesus E Zepeda Sent: Friday, 17 February 2006 10:27 AM To: 'Asterisk Users Mailing List - Non-Commercial Discussion' Subject: RE: [Asterisk-Users] How do I install speex for asterisk? Huuu! I never expected you had to recompile asterisk to add a codec. But if that is what it takes, we'll do it. I noticed that asterisk makes reference to some speex.c in the makefile file. In some of those references I saw the actual speex.c file in the paths specified. A couple of them missing by the way. That could be why speex was never taken by asterisk. Mike, does speex have to be copied to a specific directory, then compiled and installed before re-compiling and re-installing asterisk? I appreciate you took your time to reply. Regards, Jesus -----Original Message----- From: Mike Pollitt [mailto:[EMAIL PROTECTED] Sent: Thursday, February 16, 2006 15:22 To: 'Asterisk Users Mailing List - Non-Commercial Discussion' Subject: RE: [Asterisk-Users] How do I install speex for asterisk? You need to recompile Asterisk itself after installing Speex. Do a make clean, make, make install. I usually stop asterisk before that last step, by the way! -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Jesus E Zepeda Sent: Friday, 17 February 2006 5:58 AM To: Asterisk User List Subject: [Asterisk-Users] How do I install speex for asterisk? Hi, everybody: I enabled speex in my asterisk box (iax.conf), but no phone call went throug. At the asterisk console, I used the "show modules" command and it did not show the speex codec in the list. So, I downloaded the speex codec from speex.org, v1.0.5, compiled and installed in my asterisk machine. What I still don't know is: what do I need to do from the asterisk side to make it available? I just downloaded it to a directory, compiled and installed thinking that by doing a restart to asterisk it would some how know where to load it from. Any hints are appreciated Regards, Jesus E. Zepeda _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
