First guess is that the called number sent from * to the intertel is longer than expected. Check the provisioning on the PRI that used to be connected to that port (if there was one) and you will probably find that the telco was sending fewer digits for the called number than * is. You can change asterisk or change the intertel, as long as they agree on how many are sent.
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Erik Anderson Sent: Monday, March 06, 2006 5:20 PM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: [Asterisk-Users] PRI CID signalling not working? Hello - I have (finally) obtained a fair amount of success in connecting my Intertel Axxess PBX to an asterisk box via a T1 PRI. I can place calls from the Intertel side through the T1, out to an IAX2 softphone and the calls get routed correctly and all of the CID information stays intact. However, when I call from the IAX side to an extension which should route back through to the Intertel system, it's looking like either the CID information isn't getting passed correctly or the Intertel system isn't correctly receiving the d-channel data that is sent by the asterisk box. What's happening is that no matter what extension I dial from my softphone, it gets routed to the "operator" extension of my Intertel PBX. Has anyone had experience with troubleshooting this? I have call routing tables set up on the Intertel that *should* be taking care of this, but it's not working. Here are a few snippets of my config files - are there any glaring errors? zapata.conf: [channels] signalling=pri_net ; pri_cpe = PRI slave ; pri_net = PRI master switchtype=national echocancel=yes ; You can set this to 32, 64, or 128, tweak to your needs. echocancelwhenbridged=yes echotraining=400 ; Asterisk trains to the beginning of the call, number is in milliseconds callerid=asreceived group=1 context=logic; Points to the default context of your extensions.conf channel => 1-23 ; Set this to 1-15,17-31 for E1 extensions.conf: [globals] TRUNK=Zap/g1 ; Trunk interface [logic] exten => 270,1,Dial(IAX2/erika_idefisk) exten => 271,1,Dial(IAX2/erika_idefisk) exten => _ZZZ,1,Dial(${TRUNK}/${EXTEN}}) iax.conf: [erika_idefisk] type=friend username=erika secret=foobar host=dynamic context=logic Any ideas? Thanks! -Erik -- Erik Anderson http://andersonfam.org _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
