Hi,
zapata.conf and zaptel.conf has different sintaxes. In zaptel.conf, you
should use only:
fxsks=3-4
The zapata.conf of yours seems to be ok, but I don't see the group=1 on
it. And that "-- Executing Dial" stuff has nothing to do with receiving
a call from PSTN.
[]'s
MM
[EMAIL PROTECTED] wrote:
helleo ,I have one wildcard installed on the server,and configured it.there are
two modules which both FXOs .all configurations complete,and when we start asterisk use "asterisk -vvvvc",it shows asterisk ready,no warnings.afterwards when the sever connected to the PSTN in the one port which configured,and have a phone line connected to the other port then run "zttool",however it shows just one channel active.I can't understand ,why? I try to dial the PSTN number from another external phone to test,but the call is not ringing.But in the asterisk cLI there are some infos following as :
-- Starting simple switch on 'Zap/4-1'
-- Executing Dial("Zap/4-1", "Zap/g1") in new stack
those are my configurations:
-extension.conf--
[incoming]
exten => s,1,Answer()
exten => s,2,Echo()
-zapata.conf--
context=incoming
signalling=fxs_ks
channel => 3-4
-zaptel.conf
context=incoming
signalling=fxs_ks
channel => 3-4
hope to hear from you
thanks & regards
--
This message was sent on behalf of [EMAIL PROTECTED] at openSubscriber.com
http://www.opensubscriber.com/messages/[email protected]/topic.html
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
