Yes,
Same configuration as Martin.
1.for incoming call just set the 3804 "hotline" to one sip
extension number.
2.for outgoing call, you just using regular dail command to
pass the phone number to 3804 (3804 is a 4FXO port device, the call from
ip side always pass to FXO Port). You can telnet to the 3804 and enable the
one-stage calling function.
Regards,
Kevin
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Martin Joseph
Sent: Sunday, March 26, 2006 12:13 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: [Asterisk-Users] welltech Wellgate 3804 in SIP mode
On Mar 25, 2006, at 6:26 PM, Erick Perez wrote:
Martin, i guess im in dumb mode today because i don't get what you say, may also be because this will be my first welltech to configure.Sorry, I don't know if the 3804 actually uses a similar config setup to my 3701a, so it might not be you at all.
what im trying to do is:
remote_voip_gateway-------->asterisk----------->fox/fxs/and_international_voip_providers
call will always go -----> this way, no incoming calls from the right of the diagram side to asterisk.
Ok, then if it is similar to mine, all you need to do is set the SIP configuration screen for the wellgate. Look under "SIP Config" and "security config". Then to dial, you just use (repeated from below):
For outbound ones, I think I just have a regular old
Dial(SIP/[EMAIL PROTECTED] in my dialplan where 2003 is the FXO port.
Good Luck,
Marty
PS I had to reflash my device with the SIP formware, as it arrived with H323 firmware.
On 3/23/06, Martin Joseph < [EMAIL PROTECTED]> wrote:
On Mar 22, 2006, at 10:24 PM, Erick Perez wrote:
> Hi, does anybody have a working config or tips to connect the welltech
> wellgate 3804 (4fxo) unit to asterisk via SIP ?
> I think I register it via SIP with my * box, but when sending calls
> from * to the wellgate the unit does not pass the call to any of the
> fxo ports.
>
I am using the 3701a, which is a 1 FXO 1 FXS deal.
The trick for me was the "routing table" or something like that from
the Web based configuration screen. There I changed the default for
the FXO to point to IP, and the IP to default to the FXO.
Then I also have the "line configuration" set so the extension I want
to ring ie 2020 is the "hotline" for the FXO.
For outbound ones, I think I just have a regular old
Dial(SIP/[EMAIL PROTECTED] in my dialplan where 2003 is the FXO port.
HTH?
Marty
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
--
-------------------------------------------
Erick Perez
Linux User 376588
http://counter.li.org/ (Get counted!!!)
Panama, Republic of Panama
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ --Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
