Tzafrir Cohen wrote:
On Sun, May 07, 2006 at 12:21:53AM -0400, Roger Gulbranson wrote:
On Sat, 2006-05-06 at 19:43 -0400, Steve Totaro wrote:
Roger Gulbranson wrote:
On Sat, 2006-05-06 at 07:42 -0400, Steve Totaro wrote:
I have a TDM4xxp card with no modules. My question is, will this card
be sufficient to provide timing or does it need to have modules?
Yes, it will be -- I use such a card in one of my SPARCs. IIRC though,
you need to tweak the source to allow it to load wctdm without a module.
Can you give me a little clue about what needs to be tweaked? A very
nice clue would be very specific and line by line ;-)
It's been a year and a half since I worked on this so my memory is a bit
hazy.
My guess is that the line is:
static int timingonly = 1;
The original value was a zero.
timingonly
Try 'modinfo wctdm' . This is a parameter of the module (at least now).
So it can be set at modprobe time or through modprobe.conf .
-- Tzafrir
I was able to install the card and get wctdm to load with the timingonly
= 1 setting.
I cannot run ./zttest though, I get "Unable to open zap interface: No
such device or address" Does this mean that I am not getting timing?
Do I actually have to configure any of the conf files at all or should
modprobe zaptel, modprobe wctdm without errors be enough.
Thanks,
Steve
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
