On Thursday 25 May 2006 13:06, Sean Cook wrote: > There are no known compatibility issues (IRQ, IO etc) with ANY Sangoma > hardware and ANY make/brand of PC/server- NONE
Not exactly. Their hardware and drivers play nicely far more often than the older Digium boards, but I have personally been bitten by their S518 not playing nice with their A101u in a Dell P3 system. The S518's driver would cause very clear and repeatable audio "chirping" on the T1. Replace the A101u with a T100P and no issues whatsoever. This was about 18 months ago. Drivers have changed since then, and this may no longer be an issue. That particular system has been EOLd so it's a complete non-issue to me. I've mentioned this to Sangoma in passing, but seeing as it is a fairly irregular case, I don't expect any fuss to be made of it. Digium's cards are historically much finickier (is that a word?) but I know that their rev2 TE405/410 and latest TDM400 carrier is significantly better than their older stuff in terms of compatibility. Technically speaking, both Sangoma and Digium use the *identical* Xilinx Spartan II FPGA for their PCI interface (on the A104 and TE405/410). I feel fairly confident to also say that they will be using the same PCI VHDL "block" to interface that part to the PCI bus. So what this comes down to, by and large, is the drivers. There have been some hardware PCI interop issues with Digium's stuff, but I know for a fact that these have been fixed in their rev2 hardware. Also technically speaking (but not PCI-speaking), Sangoma's multiport cards can do some things that the Digium cards cannot. Specifically, Sangoma's cards have no issues whatsoever with having their spans synchronized to completely different clocking sources. This is achieved by using a single-port framer for each span. Digium's framer is a single chip that supports four spans, and one of the framer's limitations is that all spans of the same technology (T1/E1) must share a clocking source. (I've dug around in the framer's datasheet several months ago for a separate nefarious project, which is why I know this.) For MOST people this isn't an issue, but it comes up now and again. Sangoma's single, dual and quadspan cards can also fit in a half-height PCI slot. Digium's quadspan cannot, and I believe that their dualspan cannot do this, either. For some people this is an issue. Sangoma's echo cancellation option board also seems to be far "heftier" than Digium's VPM. I've got an A104d that replaced a TE406 and completely eradicated all of my echo troubles. I like Digium's products, and I like Sangoma's products. I'm not endorsing one over the other in this post at all; I'm merely pointing out that your "none" and "never" are strong words that no vendor can meet. Sangoma's response to oddball hardware has been MUCH more customer-oriented than Digium's, at least historically speaking. I believe that Digium's made *significant* improvements in their customer relations over the past little while, but by and large the products I buy from both vendors "just works" and I hardly ever have to call support. -A. _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
