You could try pri debug span 1 and watch for anything that looks strange.
Lacy Moore - Aspendora wrote:
I'd change s,104 to something along the lines of a playback for
debugging purposes just to be sure, but it looks as though all of your
channels are busy. The way I am reading that is that you have 4 voice
channels on your PRI, is that correct? Could you already have 4
simultaneous calls going on when this call is placed?
Other than that, the only thing I can think of is that you are getting
an all circuits are busy from your carrier. Haven't yet encountered
this, so I don't know how this is reported on a PRI.
I guess one more thing, are you sure you are dialing the correct number?
Maybe one more item, and this goes along with the first. Is TRUNK1 is
defined as a group? I ask this because if not, then I believe
Asterisk will use only the defined channel and not go to the next
available channel. That being the case, you cannot have more than 1
simultaneous call.
On 5/26/06, *Kevin Smith* <[EMAIL PROTECTED]
<mailto:[EMAIL PROTECTED]>> wrote:
Hey everyone,
A few employees have noticed some problem here and there when
trying to
make outgoing phone calls. After it happens, they try again, and are
able to call through.
The dial plan for outbound calling looks like below. Which I know they
are getting to the Congestion part (which explains the busy) but
what I
can't seem to figure out is the cause for why they are getting
sent there.
exten => s,1,SetCallerID(${ARG1})
exten => s,2,Wait(2)
exten => s,3,Dial(${TRUNK1}/${ARG2})
exten => s,4,Congestion(10)
exten => s,104,Congestion(10)
The log for a call looked like this
May 26 12:21:08 VERBOSE[6997] logger.c: -- Channel 0/4, span 1 got
hangup request
May 26 12:21:08 VERBOSE[16613] logger.c: -- Zap/4-1 is
circuit-busy
May 26 12:21:08 VERBOSE[16613] logger.c: -- Hungup 'Zap/4-1'
May 26 12:21:08 VERBOSE[16613] logger.c: == Everyone is
busy/congested
at this time (1:0/1/0)
My question is it asterisk having an issue with the PRI or is the PRI
really reporting the number is busy. I know one case like this I was
calling home, and which when I got through to them, they were not even
on the phone. Are there any tests that I can run on the T1 card in the
server to the PRI? Any suggestions would be helpful.
Kevin
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com
<http://Easynews.com> --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
--
Lacy Moore
Aspendora, Inc.
------------------------------------------------------------------------
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
