Hi Nick, On Wed, May 31, 2006 at 12:58:55PM +0100, Nick Burch wrote: > Hi All > > I've got an asterisk system, using a couple of Xorcom Astribanks to > provide FXS ports. (I'm using the zaptel 1.2 branch, if that matters) > > I've noticed that the ringing volume is a lot louder than on our old phone > system, and people are starting to complain it's too loud. (This is the > noise the phone makes when it rings, not the noise in your handset when > you ring someone else) > > > Having had a look through the code, I think that Asterisk passes the > responsibility for ringing the phones to Zaptel, which drives the > astribank to make them ring. Is this correct?
Anything that analog is probably the job of the digital-to-analog chip used. Not of the digital stream sent by Zaptel. > > Despite looking through the zaptel source code, I couldn't find anywhere > that screamed "I'm the volume your phones ring at". Just a lot of scary > numbers in zonedata.c, and cryptic comments in tone_zone.h > > > Could someone suggest how I'd go about making the zap ring volume quieter? I don't have the specs here. I'll just note that component used in the Astribank is quite similar to the one used by Digium in the TDM400P and TDM2400P . Grep for proslic. Note, however: $ cat /proc/xpp/XBUS-0/XPD-0/slics # Writing bad data into this file may damage your hardware! # Consult firmware docs first SLIC_REPLY: D reg_num=0x0, dataH=0x0 dataL=0x0 -- Tzafrir Cohen sip:[EMAIL PROTECTED] icq#16849755 iax:[EMAIL PROTECTED] +972-50-7952406 [EMAIL PROTECTED] http://www.xorcom.com _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
