Try to do ztcfg –s before you run ztcfg -vv
Henk
From: [EMAIL PROTECTED] [mailto: [EMAIL PROTECTED]] On Behalf Of Jean-Louis curty
Sent: woensdag 31 mei 2006 12:52
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: [Asterisk-Users] Need help with Junghanns Quadbri
Hi everybody
I hope that somebody can help me with the following ....
I have
2 quadbri cards
2 - 1t0 cards
1 pabx alcatel 4200
I would like to connect my asterisk to the alcatel ,
I installed bristuff 0.3.0-1p ,
loaded the zaphfc driver in NT mode
configured zaptel and zapata , it works great.
then I removed the 1 t0 card,
added the quadbri
loaded qozap : insmod qozap.ko ports=15 ( 4 ports in NT )
adjusted the zaptel zapata, specified the right signalling, right context
ran ztcfg -vv ( 12 channels configured )
started asterisk,
I get layer1 down message on the 4 ports,
leds remain red
what ever I do in my conf , I am not able to get a reaction from the card ( I tried with my two quadbri, on 2 different pc's )
what can I check ?
thanks
jl
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ --Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
