Hello all. I have a Digium TE110P board and when I do a "zap show
status" on CLI I get:
Description Alarms
IRQ bpviol CRC4
Digium Wildcard TE110P T1/E1 Card 0 OK 0 0
0
IRQ = 0 ?
In lspci I have the board in IRQ 15:
0000:01:06.0 Network controller: Tiger Jet Network Inc. Tiger3XX
Modem/ISDN interface
Subsystem: Unknown device 79fe:0001
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR+ FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (250ns min, 32000ns max)
* Interrupt: pin A routed to IRQ 15*
Region 0: I/O ports at c800 [size=256]
Region 1: Memory at fc5ff000 (32-bit, non-prefetchable) [size=4K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI+ D1- D2+ AuxCurrent=0mA
PME(D0+,D1-,D2+,D3hot+,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
There is no difference when I load the module using:
modprobe wcte11xp irq=15
or
modprobe wcte11xp
This is normal ?
Thanks
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
