Barzilai escribió:
Franciso,
can you make a call to the outside world, from the FXS port and going
out the FXO port?
I mean, without Asterisk in between. (The SPA300 can be configured that
way)
I'm asking because I remember having trouble with the SPA recognizing
that the FXO line was "alive" when I plugged in a Panasonic PBX line.
But when I connected it directly to the phone company it recognized the
voltage or whatever.
If I remember correctly, the "503" error message is exactly what I was
getting. But this was almost 2 years ago.
BarZ
Francisco Seratti wrote:
Dave Fullerton escribió:
Francisco Seratti wrote:
Hi pals, im trying to save some money in
cellphones calls, so i bought a GSM gateway and a Sipura SPA3000
gateway.
The GSM gw is currently working, and now im trying to configure the
SPA, but every call i send, i get a 503 service unavailable.
Im using this extension to match cell calls and sendthem to the spa:
exten => _15.,1,Dial(SIP/300/${EXTEN}) ; cellphones are 15xxxxxxxx
and 300 is the spa3000 extension, registered OK
exten => _15.,2,Hangup
In the dialplan section of the sipura, i ve tried many different
options like xx.<:@gw0>, (xx.) and many others.
I cannot find a formal configuration doc for this device, so if you
giveme a hand to configure it or tellme where to start, or where
is the problem i would be very pleased.
This may be a stupid question, but are you sure you are using the
registration for the FXO port (PSTN Line) and not the FXS port (line 1)
? I usually don't give my trunk lines extension numbers is why I ask.
-Dave
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
__________ NOD32 1.1730 (20060829) Information __________
This message was checked by NOD32 antivirus system.
http://www.eset.com
Dave, thanks for your time. Yes, im sure it was the FXO port that i
regitered in the Asterisk. Do you know in which cases a 503 "Service
Unavailable" is obtained?
I also configured the syslog for this line and im getting just before
the 503 response, the line: "<151>AUD:Stop PSTN Tone". I dont
know what is this, but maybe a clue. If you need an extra data or
config,, ask to me.
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
__________ NOD32 1.1730 (20060829) Information __________
This message was checked by NOD32 antivirus system.
http://www.eset.com
I did not tried that configuration, how should i configure Line 1 to
make calls through PSTN Line ? I will also try with a telco line, maybe
i have to config the tone frequencies to adapt them to the gsm gw tone.
F
--
Francisco Seratti
Sunesys Telecomunicaciones
Bouchard 644. 5to A. Puerto Madero
[EMAIL PROTECTED]
Tel: (54) 011- 4311-9009 (Rotativas)
|
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
