Hoping someone can point me in the right direction. I have the following setup:
Trixbox latest (asterisk 1.2.11) DID thru IAX trunk (EXGN/Vitelity) Termination thru IAX trunk (EXGN/Vitelity) 3 GXP-2000 phones with firmware (1.1.0.16) 6 Digium g729 licenses I have no codecs specified per trunk or extension. In iax.conf and sip.conf, with disallows=all and allow=gsm, everything works fine. When I change it to allow=g729, I have problems with incoming calls, and calls from the extensions into the system (voicemail, etc). Outgoing calls work just fine (no transcoding). Incoming calls are automatically answered by the system attendant with a quick greeting, then dumped into a call queue. With g729 enabled, calls get answered, but no audio is heard. Same with phones trying to check voicemail. After hanging up, it doesn't release the codecs. 'show g729' gives: 6/0 encoders/decoders of 6 licensed channels are currently in use And it will stay like that until asterisk is restarted. I'm assuming its a transcoding issue with the system attendant/prompts, but I can't see how it would need more than one license per incoming call, much less six, and why the licenses aren't released after the call ends. And I haven't found a console command that actually lists the per license usage. Any help resolving this would be appreciated. I already purchased 3 more licenses than I theoretically need, just to throw $30 at the problem and save some hair, but that didn't work. Thanks in advance. __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
