BJ Weschke wrote:
On 9/13/06, Steve Totaro <[EMAIL PROTECTED]> wrote:
BJ Weschke wrote:
> On 9/13/06, Steve Totaro <[EMAIL PROTECTED]> wrote:
>> Doug Lytle wrote:
>> > Steve Totaro wrote:
>> >> I am trying to connect a Definity G3 to an asterisk system. I
had it
>> >> working OK with the exception of the caller ID on the Definity
>> >> handsets just
>> >
>> > He wants to know if your Definity is an S, SI or an R?
>> >
>> > Doug
>> >
>> I am not sure, it is a refrigerator sized unit with three
cabinets. The
>> manual was printed in 1988 and is ATT&T Definity Communications
System
>> Generic1 and Generic3.
>>
>> If you need more, I can go to the remote system and provide more
>> details.
>>
>> I REALLY appreciate you helping on this.
>>
>
> Sounds like a G3R. How are you signaling between the two? PRI?
>
Yes. I have two ISDN communication processor links setup which I later
read on google was not supported. Now I cannot remove the new entry. I
just get "identifier not assigned"
What you'll want to do in order to set this up, is build a trunk
group in DSA that consists of the two T1's, and then you'll want to
build a signaling group that uses "isdn" signaling and then (probably
3-4 pages over in DSA) you'll want to assign all the channels of those
T1s as "members" of that signaling group.
On the asterisk side you'll want to setup the trunks as pri_net.
Put a T1 crossover cable in between, if there's no carrier loops
involved, and then you're done.
OK,
Here is what I did.
I setup a ds1 with standard T1 pri settings and set to the network.
I setup a trunk-group with all the ports on that ds1, set it to isdn-pri
and tie and set the signaling to the step below
I setup a signaling-group with the primary d-channel as the 24rth port
on the ds1 using associated signaling
I setup a data-module
I setup communication-interface link
I setup communication-interface processor to isdn h priority
I went back to communication-interface link and enabled it.
Everything worked perfectly. The d channel came up and 23 b channels
through the definity and the new ivr server. Calls in and out sounded
great and no PRI errors whatsoever.
I repeated the same steps above with the same settings but obviously
different boards and identifiers.
Now the D channel goes up and down on both links and the b channels
never come up
I remove everything I just added (new trunk-group, signaling group)
I tried to remove the data-module but it errors saying I have to remove
it from the communication-interface link
I tried to remove the data-module from the communication-interface link
but that errors saying I have to remove the communication-interface
processor
I tried to blank out the second entry for the communication-interface
processor and it errors saying “Identifier not Assigned”
I have busied out everything related to the board and data-module and
also tried to change the second isdn value in communication-interface
processor but once I get all the values filled in, I get the same error
“Identifier not Assigned”
The original PRI still does not work. The D channel comes up and down
and no B channels.
Thanks,
Steve
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
