Dmesg reports: Zapata Telephony Interface Registered on major 196 Zaptel Version: 1.4.0 Echo Canceller: MG2 ACPI: PCI interrupt 0000:00:0c.0[A] -> GSI 16 (level, low) -> IRQ 185 wcfxo: DAA mode is 'FCC' Found a Wildcard FXO: Wildcard X100P Capability LSM initialized
When I run zttool it says that alarms: red. The card is connected to the phone line. Anybody any idea what the problem is? -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Charlie Grosvenor Sent: 22 January 2007 20:08 To: asterisk-users@lists.digium.com Subject: [asterisk-users] X100P how do i recieve incomming calls? I have just purchased a 2nd hand X100P, if I do a ztcfg -vv I get: "Zaptel Version: 1.4.0 Echo Canceller: MG2 Configuration ====================== Channel map: Channel 01: FXS Kewlstart (Default) (Slaves: 01) 1 channels configured." My understanding of the above is that the zaptel driver has detected the card. What do I now need to do, in order to get an incoming call to work with asterisk? I assume I need to make some sort of change to /etc/asterisk/zapata.conf in order to tell asterisk about the card? Thanks _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users