Hello, Do you include in your zapata.conf
answeronpolarityswitch=yes hanguponpolarityswitch=yes There are any problems with hang up Regards On 1/29/07, Lee Jenkins <[EMAIL PROTECTED]> wrote:
Hi everyone, I just installed a TDM02B and surprisingly, I had really no problems except one. If I place an outbound call on the Zap line (Zap/3), everything works fine except when the called party hangups before I do. I do get congestion, but that is expected. However, when I try to make another outbound call using that Zap line, the CLI shows that the call is being dialed, but nothing happens and I get the telco's message "if you'd like to make a call, hang up..." after a few seconds. If I call out to a party on that Zap line and hangup first, I do not experience that problem. It looks like Asterisk is not getting the termination signal from the telco (Verizon) when the other party hangs up first. Running show channels at any time after the call is disconnected (by either party) shows 0 active calls/channels. When the problem occurs, calling that ZAP line from outside seems to reset it as well. I'm sure it's something obvious I've overlooked, but I'd appreciate any pointers. Thank you, -- Warm Regards, Lee _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
