Doh, I didn't compile meetme support into this install because it
said it required a zaptel card for the hardware timers. I have a
spare zaptel card, but I'd rather not install it if I don't have to.
I didn't know of the ztdummy module, I will compile this and then
recompile asterisk.
I could certainly use the sla config samples or any info you have for
this. The documentation included for the SLA feature is not the
greatest. I assume that when you set up the shared lines on the
phone itself, you mark those extensions as shared?
Thanks!
~jay
On May 5, 2007, at 12:46 PM, David W. Rice wrote:
SLA requires meetme which requires at a minimum ztdummy. So, you must
compile and install zaptel, then compile and install asterisk 1.4.3
and
the sla commands will be in the CLI. Let me know if you need help
setting up SLA on Polycom phones with *. I've done it successfully
and
have the configs. I'm going to put them on the web some time soon.
-----Original Message-----
From: Jay Austad [mailto:[EMAIL PROTECTED]
Sent: Friday, May 04, 2007 8:48 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: [asterisk-users] SLA broken in 1.4.3?
I configured my sla.conf to use with a Polycom phone. I have no idea
if I did it right, however, none of the console "sla" commands
exist. Do I have to something special to compile in this support, or
should it just work out of the box?
~jay
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
