On Fri, 1 Jun 2007, Gavin Henry wrote:
Dear all,
I think this is common, or at least how it is supposed to be, but
whening dialing over a ZAP channel, it's taking around 5~ seconds to
ring on the over end, likewise inbound.
This is just with a normal Dial command.
It's "normal" for an analogue Zap channel.
Asterisk has to "sieze" the line (after a basic check to make sure the
channel is free), that may entail a delay of a second or so while it makes
sure there there is a dial-tone (actually, I'm not sure it waits for a
dial-tone), then it sends the digits out via DTMF - that might take a
second or 2 for a long number - then it's up to the PSTN switch at the
other end to connect the call - depending on the technology, this might
take several seconds.
What you can do is connect to asterisk (asterisk -r), set verbose 9999,
then initiate a dial and you'll see the dialplan progress and you can work
out yourself where the longest part of the delay is...
Inbound ought to be answered as soon as asterisk "hears" the ringing
signal - but this might be one whole ring time from the ring starting,
depending on how caller-id is being handled in your country, again,
monitor it by looking at the output on the console, and by connecting an
existing analogue phone in paralel with the incoming Zap line.
Gordon
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
