-- Jonathan Moore Director of Technology Winfield Public Schools Office 620.221.5100 Fax 620.221.0508
Quoting Steven Critchfield <[EMAIL PROTECTED]>: > On Thu, 2003-12-04 at 13:42, Jonathan Moore wrote: > > Quoting Steven Critchfield <[EMAIL PROTECTED]>: > > > > > On Thu, 2003-12-04 at 11:49, Jonathan Moore wrote: > > > > I just purchased a T100p from digium and a Carrier Access Access Bank > 1 > > > channel > > > > bank (12fxs/12fxo). I have the setup partially working thanks to some > help > > > from > > > > IRC. However I still have the following issues I can't seem to resolve > > > > > > > > 1. When calling into the system from the PSTN call hangup is not > detected. > > > * > > > > leaves line in use until it is shutdown. > > > > > > You need to get disconnect supervision on you phone lines. Nothing short > > > is probably going to work for you. > > > > > > > Formerly I was using a single line FXO card from Digium and it worked > perfectly > > with kewl start signalling. Does this still mean I need to get disconnect > > supervision from the telco? Just changing from ls to ks in configs doesn't > seem > > to have any affect. > > Where you using the busydetection and I forget what the other one is? If > so, you can probably turn them on for these channels as well and get it > to work again. No I wasn't using either before (unless they default) I didn't have either keyword in the file and it seems to detect hangup better. Only former issue with single fxo card was, if I dialed through to an extension and hung up before answer the extension would continue ringing for 5 seconds after hangup. With keywords on it now seems to take 30 seconds for the call to clear if I hangup in main directory. I will have to test ... Takes about 8 seconds for internal phone to stop ringing. Line doesn't clear for another 30-60 seconds. Won't this cause major havic in voice mail? Better yet tieing up lines? > > > > > 2. When calling an analog phone connected to channel bank the phone > > > doesn't > > > > ring. If you are in call and some else calls the extension you get the > > > call > > > > waiting tones and a flash works to flip to the new line. > > > > > > Do any of the phone lines ring? Sounds like you have one of the AB1's > > > that are known to get burnt out ring generators. > > > > Is there a way to definitively test the ring generators on the channel > bank? > > Outside of verifying the switches and jumpers are right, and then seeing > if the ringers work when dialed, not that I know of. Anyone know the correct jumper settings for an access bank one. I am going off of what is posted at http://www.billheckel.com/asterisk/cac.html I think this setup assumed 2 fxs cards. > -- > Steven Critchfield <[EMAIL PROTECTED]> > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > Visit Winfield Public Schools at http://usd465.com ------------------------------------------------- This mail sent through IMP: http://horde.org/imp/ _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users