I am new to * and after getting some much needed help from someone on the IRC channel with my config files I got my system up and going. I have several dlink DG 104s's and they seem to work fine on my LAN the only trouble I have is trying to get them to work thru double Nat by that I mean on both ends. My * box is behind Nat and I am trying to setup a 104s at another location behind Nat no luck so far but I will get it somehow. I have read in the lists that they loose their config but I have not had that trouble the only advice I have is if you upgrade the firmware reset to factory default after then configure the units with a serial cable
James Schenck Egraph Design Inc. Arkansas Online Internet Services (870) 857-3287 IAXTEL(700) 857-3287 [EMAIL PROTECTED] -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Juan J. Sierralta P. Sent: Friday, December 05, 2003 11:14 PM To: Asterisk Users Subject: [Asterisk-Users] MGCP IADs Hi, For MGCP users. Is there any success stories with any MGCP IAD vendor. I�m trying to find an IAD which works with Asterisk. I�ve tried the Cisco IAD 2430 without success; but SIP on this IAD works but it�s limited (no authentication, no notify messages, etc) and with higher density IAD (16 or more ports) it�s nice to control using MGCP. Any information will be apreciated ! Thanks. -- Juanjo sin .sig _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
