A critical lesson I learned was not to rely to heavily on the AMI, especially when there are other ways of doing the same thing that are just as simple.
I suggest, rather than using AMI originate, mv or ftp .call files. Thanks, Steve Whit Thiele wrote: > > Still having no luck with this scenario. Has anyone else experienced > problems with e&m wink lines? > > I'm thinking that there could be problems with the timing settings in > zapata.conf, but documentation is pretty light. > > How could the telco not be receiving enough digits when it works for 500 > calls...? > > Anyone have any similar experiences/ possible solutions? > > Whit > > > > > On 10/2/07, *Whit Thiele* <[EMAIL PROTECTED] > <mailto:[EMAIL PROTECTED]>> wrote: > > Hey folks, > > I'm pulling my hair out on this situation and would welcome some advice: > > I'm using the AMI Manager to Originate calls onto 2 E&M wink T1 > circuits via a T4XXP card from Digium. > > Everything works fine for about 600(+/- 50) calls then the Manager > is suddenly unable to launch calls. Using ZapBarge to listen to the > channels themselves you can hear the dtmf digits being dialed, but > then either there is dialtone (again), or a fast busy signal. > > I've also noticed(via ZapBarge) that before the T1 seizure that the > call launched will immediately go to an automated message claiming > that not enough digits have been dialed. The rest of the T1's become > useless right after it. > > Once the T1's get into this state, even trying to launch a call > directly through the dialplan experiences the same behavior. Its > like the T1 has locked up. > > The telco provider (quest) claims they aren't even seeing the digits > placed on the circuit. They say they see the channel being grabbed, > but no digits appearing. > > Verbose and debug show nothing out of the ordinary. > > Could this be an issue with the Digium card? Both T1's experience > the same behavior at the same time. I've tried some different > settings such as callprogress=yes and busydetect=no but nothing has > helped. Only restarting asterisk seems to allow another 600 calls to > be processed. > > I'm using the latest asterisk release version 1.4.11 and zaptel > 1.4.5.1 <http://1.4.5.1> > > Regards, > > Whit > > > > ------------------------------------------------------------------------ > > _______________________________________________ > --Bandwidth and Colocation Provided by http://www.api-digital.com-- > > asterisk-users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ --Bandwidth and Colocation Provided by http://www.api-digital.com-- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
