For the HFC-4S (4 bri channels) you need to qozap driver not zaphfc Regards
Stelios S. Koroneos Digital OPSiS - Embedded Intelligence http://www.digital-opsis.com Quoting Elijah <[EMAIL PROTECTED]>: > Hi, > > I'm very new to asterisk and managed to set one up in debian, I > installed via apt-get the asterisk and asterisk-bristuff packages. I > downloaded the bristuff source as well. > > I managed to get as far as loading the following modules: > zaptel 199144 4 cwain,zaphfc,zttranscode,ztdummy > > But the problem now is that all channels that I try to configure gives > me an error that that device/address doesn't exist ..and only one > unconfigured device is displayed in zttool. > > > Does anyone have any experience with this type of card? care to share > some tips? > > > 0c:02.0 ISDN controller: Cologne Chip Designs GmbH ISDN network > Controller [HFC-4S] (rev 01) > Subsystem: Cologne Chip Designs GmbH Unknown device b556 > Flags: medium devsel, IRQ 5 > I/O ports at ccf8 [size=8] > Memory at d9fff000 (32-bit, non-prefetchable) [size=4K] > Capabilities: [40] Power Management version 2 > > > > Regards, > Elijah > > > > > _______________________________________________ > --Bandwidth and Colocation Provided by http://www.api-digital.com-- > > asterisk-users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > ---------------------------------------------------------------- This message was sent using IMP, the Internet Messaging Program. _______________________________________________ --Bandwidth and Colocation Provided by http://www.api-digital.com-- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
