Quoting Mandeep Singh Bhabha <[EMAIL PROTECTED]>:
> what i did to configure SPA3102 is ...
My problem is that normal SPA3102 configurations just don't seem to
work. I can't even get the FXS port to register. I'm beginning to
suspect that my unit is defective. Here's why:
If I configure the FXS port to register with my Asterisk server using
the most basic sip.conf configuration *without* a password, then it
does actually register. The only problem is the address it gives:
bitis*CLI> sip show peers
Name/username Host Dyn Nat ACL Port Status
8000/8000 127.0.0.1 D 5060 OK (1 ms)
That's right: instead of 192.168.1.8, it's telling Asterisk that it's
available on the loopback address! I'll bet this is why it's not able
to register using a password. I got the same results with three
different firmware versions.
Still, it's an unusual way for a device to be broken. Could there be
another reason for this behavior? Otherwise I'll just have to try to
explain it to the vendor and perhaps to Linksys tech support and ask
for my money back.
Cheers,
Jaap
_______________________________________________
-- Bandwidth and Colocation Provided by http://www.api-digital.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
