On Fri, Oct 17, 2008 at 5:24 PM, Ron Joffe <[EMAIL PROTECTED]> wrote: > Here is my hardware configuration > > TELCO --- PRI1 --- PBX --- PRI2 --- Asterisk > > The PBX is a Siemens Hicom 200 EX (Model 80) > > We are connecting between the PBX and Asterisk using QSIG switch type. > > What I want to do is the following: > > 1. Call comes from TELCO via PRI1 and enters PBX > 2. PBX Routes call to Asterisk via PRI2 > 3. Asterisk does some call handling (IVR) > 4. Call needs to be transfered to an extension on the PBX. > > I can easily set up a dial command to pass the call back to the PBX from > Asterisk along PRI2 but this uses 2 B Channels. > > How do I tell asterisk to send a transfer request to the PBX so Asterisk is > out of the loop? > > Thanks, > > Ron > > > > -- > Ron Joffe > Siena Tech, Inc. > 3319 Willow Glen Drive > Oak Hill, VA 20171 > (919) 928-0404
I would engineer the system so that Asterisk is in the middle rather than the far end. Is there a reason why you don't want to or cannot do that? TELCO --- PRI1 --- Asterisk --- PRI2 --- PBX I have done dozens and dozens of this type of implementation, sometimes you have to be very creative, but I have never failed. -- Thanks, Steve Totaro +18887771888 (Toll Free) +12409381212 (Cell) +12024369784 (Skype) _______________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users