I don't have any experience with E1, but here are some comments from the T1 perspective (on a 2800 series Cisco). Here is also a link to my collection of Cisco voice debugging commands: http://thurmantech.com/node/5
On Thu, Oct 15, 2009 at 3:27 AM, Phibee Network Operation Center <[email protected]> wrote: ! Something like this to define what clock to use (internal usually causes a lot of Slip/Error seconds) ! but don't quote me on the following line, I haven't used E1 or the 5300 ! network-clock-select 1 E1 0 > isdn switch-type primary-net5 > ! > voice service voip > sip > ! > voice class codec 400 > codec preference 1 g711alaw > codec preference 2 g729r8 > codec preference 3 g723r63 > codec preference 4 g711ulaw > ! ! You don't seem to use either voice class, do you need both? > voice class codec 500 > codec preference 1 g729r8 > codec preference 2 g723r63 > ! > controller E1 0 > framing NO-CRC4 ! linecode ? ! cablelength ? > pri-group timeslots 1-31 > description E1 Beta-Test > ! > interface Serial0:15 > no ip address > encapsulation ppp > isdn switch-type primary-net5 isdn incoming-voice voice > no cdp enable > > > voice-port 0:D > ! > ! > ! > dial-peer voice 10 voip destination-pattern . redirect ip2ip > session protocol sipv2 > session target ipv4:IP_OF_ASTERISK:5060 > session transport udp > dtmf-relay rtp-nte ! codec g711alaw ! If you define the codec class, might as well use it voice-class codec 400 dtmf-relay rtp-nte > no vad > ! > dial-peer voice 42 pots ! Don't make both patterns the same, maybe add a trunk prefix here ! destination-pattern .T destination-pattern 8T incoming called-number .T > direct-inward-dial > port 0:D > ! > sip-ua > retry invite 3 > retry response 3 > retry bye 3 > retry cancel 3 > timers trying 1000 ! Don't need this, since you specified it on the dial-peer ! sip-server ipv4:IP_OF_ASTERISK > ! Good luck! -Jonathan _______________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- AstriCon 2009 - October 13 - 15 Phoenix, Arizona Register Now: http://www.astricon.net asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
