Hi there, I just upgraded a relatively old Asterisk installation (1.2) in our office to a relatively new version (1.6svn from last wednesday) which runs a Junghans QuadBRI card [1].
To get this flying I got dahdi-linux, dahdi-tools and libpri from SVN as well. After a while of juggling it "works". What doesn't work: connected ISDN devices (Gigaset phones connected to QuadBRI with a port in NT mode, signalling via bri_net_ptmp) can not transfer calls by pressing "#". SIP phones can. I'm at a point where I can't even get *any* output to debug. I went through the relevant configs as good as I can a couple of times but am out of ideas. I'm guessing that this is somehow related to either Asterisk not being able to monitor the call for inband DTMF (which I can prove how?) or something in the relatively new bri_net_ptmp code that breaks it (which I can't prove either). A pointer how to debug this further would be very appreciated. Best regards, Christian [1] lspci output of QuadBRI 02:0c.0 ISDN controller: Cologne Chip Designs GmbH ISDN network Controller [HFC-4S] (rev 01) -- Christian Theune · c...@gocept.com gocept gmbh & co. kg · forsterstraße 29 · 06112 halle (saale) · germany http://gocept.com · tel +49 345 1229889 0 · fax +49 345 1229889 1 Zope and Plone consulting and development _______________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users