Have an intersting issue whem migrating a site from Zap on 1.3 to DAHDI on 1.4.. Nothing special about the hardware - older TDM400 card, 2 red modules fitted...
Both channels work fine under 1.2/Zaptel. With 1.4/DAHDI both channels still work OK, but only for one line - the 2nd line causes it to refuse to dial-out no matter which port it's plugged into. The Lines are bog-standard BT analogue lines and we're about 2Km from the exchange. Both sound good to me and dial out OK with a test phone connected to them, but only one will dial-out via the PBX. This is what I see: [Jan 1 05:14:14] WARNING[1200]: app_dial.c:1237 dial_exec_full: Unable to create channel of type 'DAHDI' (cause 0 - Unknown) == Everyone is busy/congested at this time (1:0/0/1) And yet the line isn't busy or congested - nothing's using it. The output of dsx*CLI> dahdi show status Description Alarms IRQ bpviol CRC4 Wildcard TDM400P REV E/F Board 5 OK 0 0 0 is fine, as is: dsx*CLI> dahdi show channels Chan Extension Context Language MOH Interpret pseudo default default 1 incoming default 2 incoming default So I'm a bit stuck. Why doesn't DAHDI like that particular line? What does it do to it that Zap didn't? Gordon -- _____________________________________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users