Hello,
If I connect an Asterisk 1.6 to a PBX via Q.SIG and
A (on the PBX) calls B (a SIP phone on Asterisk).
B answers and puts A on hold. Then B calls C (on the PABX) and does an attended
transfer.
Is it possible to configure Asterisk so that it does the Q.SIG Path
Replacement Feature ?
The Q.SIG "Path Replacement Feature" requires the following:
After both legs of the call are setup and Asterisk has a successful "tromboned"
or bridged call ...
Asterisk sees both 'B' channels (from trombone) are on same PRI/technology and
initiates "Path Replacement" events
a. Asterisk sends "Transfer Complete" messages to both call legs
b. QSIG Switch sends "Purpose" message on one of the legs (random 1-10sec
timer expires - 1st leg to send is it!)
c. Asterisk rebroadcasts "Purpose" message to other call leg
d. QSIG Switch sends "Disconnect" message on one of the legs (same random
timer sequence as above)
e. Asterisk rebroadcasts "Disconnect" message to other call leg
f. QSIG Switch disconnects Asterisk call legs - callers are now within QSIG
switch
Which hw/Q.SIG board shall I use on Asterisk to get this behavior ? Any PRI
board ?
Thank you and Regards,
Raoul Trevisi
--
_____________________________________________________________________
-- Bandwidth and Colocation Provided by http://www.api-digital.com --
New to Asterisk? Join us for a live introductory webinar every Thurs:
http://www.asterisk.org/hello
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
