|
Hello, my first post to the list. I have started to install and play with Asterisk. I was following some basic instructions to ‘jump-start’ my system. I have a TDM400P with one port and a X100P.
I am running the latest CVS versions (from today).
Following the steps I found for basic jump-start I did the following: Modprobe zaptel Modprobe wcfxo Modprobe wcfxs
Edited /etc/zaptel.conf and added the following lines: fxsks=1 fxoks=2 loadzone=us defaultzone=us
I then ran ztcfg –vv and receive a good response.
Asterisk started and running just fine! YES!
I then rebooted my computer for other reasons. Now the following happens: Modprobe zaptel (works)
Modprobe wcfxo ZT_CHANCONFIG failed on channel 2: No such device or address (6) /lib/modules/2.4.20-gentoo-r9/misc/wcfxo.o: post-install wcfxo failed /lib/modules/2.4.20-gentoo-r9/misc/wcfxo.o: insmod wcfxo failed
Modprobe wcfxs (works)
lsmod shows that both modules are loaded. Asterisk runs, though I have yet to try and use both boards. If I remove my changes to the zaptel.conf file, then run modprobe, then re-add my changes to zaptel.conf file I am fine.
Ideas?
Thanks, Mark Rizzo Perpetual Entertainment, INC.
|
