Hi, 1. Has someone met any success at all, connecting a Digium B410P to a Patton Smartnode 4638 (with latest 5.3 firmware) ?
2. If positive, then, which signalling was used on both sides ? My project's goal is use a Patton Smartnode 4638 to act as telco BRI lines, from a B410P-enabled asterisk box. In my testings, I can see channel is respectively up (with patton web server status page) and OK (with dahdi_tool) from both sides but I can't dial a single call ("Unable to create DAHDI for unknown reason...") from asterisk to patton. In my setup, my main settings are : Smartnode side: dss1,Net,pp,q931,q921 B410P side: euroisdn,bri_cpe,span=1,1,0,ccs,ami,bchan=1-2,hardhdlc=3 Both devices lights are green but I think this only means layer1 diag is OK. Looking at http://en.wikipedia.org/wiki/Digital_Subscriber_System_No._1, I would say DSS1 and EuroISDN are the same (but that doesn't mean both implementations are compliant to each other). The mostly troubling thing is : CLI> pri show spans CLI> Though with dmesg : [ 3923.671739] dahdi: Version: SVN-trunk-r7640M [ 3923.683743] wcb4xxp 0000:01:0a.0: probe called for b4xx... [ 3923.683743] ACPI: PCI Interrupt 0000:01:0a.0[A] -> GSI 21 (level, low) -> IRQ 21 [ 3923.683743] wcb4xxp 0000:01:0a.0: Identified Wildcard B410P (controller rev 1) at 0001dff0, IRQ 21 [ 3923.683743] wcb4xxp 0000:01:0a.0: VPM 0/1 init: chip ver 33 [ 3923.692430] wcb4xxp 0000:01:0a.0: VPM 1/1 init: chip ver 33 [ 3923.704465] wcb4xxp 0000:01:0a.0: Hardware echo cancellation enabled. [ 3923.704561] wcb4xxp 0000:01:0a.0: Port 1: TE mode [ 3923.708484] wcb4xxp 0000:01:0a.0: Port 2: TE mode [ 3923.708484] wcb4xxp 0000:01:0a.0: Port 3: TE mode [ 3923.708484] wcb4xxp 0000:01:0a.0: Port 4: TE mode [ 3923.708484] wcb4xxp 0000:01:0a.0: Did not do the highestorder stuff [ 3923.794449] dahdi_echocan_oslec: Registered echo canceler 'OSLEC' [ 3923.795577] dahdi: Registered tone zone 2 (France) [ 3923.811320] wcb4xxp 0000:01:0a.0: new card sync source: port 1 /var/log/asterisk/full does show any warning or error related to Dahdi/PRI. # cat /proc/interrupts CPU0 CPU1 0: 84 0 IO-APIC-edge timer ... 21: 4030670 0 IO-APIC-fasteoi b4xxp Regards
-- _____________________________________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- New to Asterisk? Join us for a live introductory webinar every Thurs: http://www.asterisk.org/hello asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users