I already replied to you in the asterisk-r2 mailing list. Your lines are blocked, the log is telling you that:
[May 12 08:58:43] WARNING[2689]: chan_unicall.c:1034 unicall_call: Make call failed - Blocked The only way you get that is if the line is blocked ( rx ABCD bits are 1101 or equivalent blocked for your country ) or the line is configured only for incoming calls ( not possible since chan_unicall.c hard-codes that parameter to allow calls in both ways ). Moises Silva Senior Software Engineer Sangoma Technologies Inc. | 50 McIntosh Drive, Suite 120, Markham ON L3R 9T3 Canada t. 1 905 474 1990 x 128 | e. [email protected] On Wed, May 12, 2010 at 5:03 PM, Marcelo nunes dos santos < [email protected]> wrote: > Hello, > > i'm using asterisk 1.4.9 in fedora 7, i was compiled its with this > package: > > > libpri-1.4.2 > asterisk-1.4.9 > spandsp-0.0.4 > unicall-0.0.5pre1 > libmfcr2-0.0.3 > libsupertone-0.0.2 > libunicall-0.0.3 > zaptel-1.4.4 > > i'm using a E1 pci card with R2 but they not work, when I start the > asterisk its generate this log: > > > > [May 12 08:53:24] WARNING[30814] channel.c: No channel type registered for > 'Unicall' > [May 12 08:53:24] WARNING[30814] app_dial.c: Unable to create channel of > type 'Unicall' (cause 66 - Channel not implemented) > [May 12 08:54:47] NOTICE[2613] cdr.c: CDR simple logging enabled. > [May 12 08:54:47] NOTICE[2613] loader.c: 146 modules will be loaded. > [May 12 08:54:49] WARNING[2613] res_smdi.c: No SMDI interfaces are > available to listen on, not starting SDMI listener. > [May 12 08:54:50] WARNING[2613] chan_sip.c: insecure=very at line 37 is > deprecated; use insecure=port,invite instead > [May 12 08:54:50] WARNING[2613] chan_zap.c: Unable to specify channel 1: > Device or resource busy > [May 12 08:54:50] ERROR[2613] chan_zap.c: Unable to open channel 1: Device > or resource busy > here = 0, tmp->channel = 1, channel = 1 > [May 12 08:54:50] ERROR[2613] chan_zap.c: Unable to register channel > '1-15,17-31' > [May 12 08:54:50] NOTICE[2613] pbx_ael.c: Starting AEL load process. > [May 12 08:54:50] NOTICE[2613] pbx_ael.c: AEL load process: calculated > config file name '/etc/asterisk/extensions.ael'. > [May 12 08:54:50] WARNING[2613] ael.y: ==== File: > /etc/asterisk/extensions.ael, Line 112, Cols: 34-34: Warning! The empty > context ael-dundi-e164-canonical will be IGNORED! > [May 12 08:54:50] WARNING[2613] ael.y: ==== File: > /etc/asterisk/extensions.ael, Line 120, Cols: 34-34: Warning! The empty > context ael-dundi-e164-customers will be IGNORED! > [May 12 08:54:50] WARNING[2613] ael.y: ==== File: > /etc/asterisk/extensions.ael, Line 128, Cols: 33-33: Warning! The empty > context ael-dundi-e164-via-pstn will be IGNORED! > [May 12 08:54:50] NOTICE[2613] pbx_ael.c: AEL load process: parsed config > file name '/etc/asterisk/extensions.ael' > . > [May 12 08:54:50] WARNING[2613] pbx_ael.c: Warning: file > /etc/asterisk/extensions.ael, line 141-145: The included context > 'ael-dundi-e164-canonical' cannot be found. > [May 12 08:54:50] WARNING[2613] pbx_ael.c: Warning: file > /etc/asterisk/extensions.ael, line 141-145: The included context > 'ael-dundi-e164-customers' cannot be found. > [May 12 08:54:50] WARNING[2613] pbx_ael.c: Warning: file > /etc/asterisk/extensions.ael, line 141-145: The included context > 'ael-dundi-e164-via-pstn' cannot be found. > [May 12 08:54:50] WARNING[2613] pbx_ael.c: Warning: file > /etc/asterisk/extensions.ael, line 276-283: The included context > 'ael-parkedcalls' cannot be found. > [May 12 08:54:50] NOTICE[2613] pbx_ael.c: AEL load process: checked config > file name '/etc/asterisk/extensions.ael'. > [May 12 08:54:50] NOTICE[2613] pbx_ael.c: AEL load process: compiled config > file name '/etc/asterisk/extensions.ael'. > [May 12 08:54:50] NOTICE[2613] pbx_ael.c: AEL load process: merged config > file name '/etc/asterisk/extensions.ael'. > [May 12 08:54:50] WARNING[2613] pbx.c: Context 'ael-local' tries includes > nonexistent context 'ael-parkedcalls' > > my file unicall.conf is this: > > > [channels] > > context=e1-inline > usecallerid=yes > hidecallerid=no > threewaycalling=yes > transfer=yes > cancallforward=yes > callreturn=yes > echocancel=yes > echocancelwhenbridged=yes > rxgain=0.0 > txgain=0.0 > relaxdtmf=yes > callgroup=1 > pickupgroup=1 > immediate=no > callerid=asreceived > musiconhold=default > protocolclass=mfcr2 > protocolvariant=br,20,20,20 > protocolend=cpe > group=1 > channel => 1-15 > channel => 17-31 > > and when i do any dial by asterisk return this: > > > The 'dial' command is deprecated and will be removed in a future release. > Please use 'console dial' instead. > == Console is full duplex > -- Executing [...@ext-local:1] Dial("OSS/dsp", "Unicall/g1/32719595") > in new stack > [May 12 08:58:43] WARNING[2689]: chan_unicall.c:1034 unicall_call: Make > call failed - Blocked > -- Couldn't call g1/32719595 > -- Hungup 'UniCall/1-1' > == Everyone is busy/congested at this time (0:0/0/0) > == Auto fallthrough, channel 'OSS/dsp' status is 'CHANUNAVAIL' > > > > can somebody help me? > > Sorry for my english. > > Marcelo Nunes Dos santos > -------------------------------------------------------------------------- > TI Savarsul - [email protected] > Blog: makelinux.com.br > Email/MSN: [email protected] > twitter: www.twitter.com/marcelonunes > > > > -- > _____________________________________________________________________ > -- Bandwidth and Colocation Provided by http://www.api-digital.com -- > New to Asterisk? Join us for a live introductory webinar every Thurs: > http://www.asterisk.org/hello > > asterisk-users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users >
-- _____________________________________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- New to Asterisk? Join us for a live introductory webinar every Thurs: http://www.asterisk.org/hello asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
