On 03/21/2011 06:49 PM, Dan Austin wrote:
I just finished a fresh install of 1.8.3.2 at home using the packages
Digium hosts.
After correcting a number of typo/config’o error that had crept in
over the years, I thought I had everything working.
My wife just complained that she cannot call her mother (who is using an
old IAX hardphone I left for her).
After turning up the logging level I see-
chan_iax2.c: Call rejected, CallToken Support required
Which google cays can be fixed with:
[general]
calltokenoptional=0.0.0.0/0.0.0.0
maxcallnumbers=16384
or
[peer]
requirecalltoken=no (or auto)
Either set of changes does suppress the error, but the remote device still
fails to register. No other errors/warnings are present.
If there aren't any errors or warnings appearing, then you must not have
the logging verbosity set high enough. Ensure that you've used 'core set
verbose 10' and 'core set debug 10', and that your 'console' channel in
logger.conf has all the logger levels enabled. If you still don't see
what you are looking for, use 'iax2 set debug' to enable IAX2-specific
debugging for that phone's IP address.
Worst case, use tcpdump to make a packet capture of the traffic to/from
the phone and then use Wireshark to look at what is going on.
--
Kevin P. Fleming
Digium, Inc. | Director of Software Technologies
Jabber: [email protected] | SIP: [email protected] | Skype: kpfleming
445 Jan Davis Drive NW - Huntsville, AL 35806 - USA
Check us out at www.digium.com & www.asterisk.org
--
_____________________________________________________________________
-- Bandwidth and Colocation Provided by http://www.api-digital.com --
New to Asterisk? Join us for a live introductory webinar every Thurs:
http://www.asterisk.org/hello
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
