iax server A only accept g729 codec while iaxtel is something I am not quite sure of. At the moment iaxtel only accepts gsm. I remember previously it does accept g729.
my problem due to the switching between codec when making outgoing calls to these servers.
my iax.conf has these lines:
[general]
disallow=all allow=gsm allow=g729
I believe the general context define the codec to be used when making outgoing calls. The peer context below general context is to governed codec to be used for incoming calls. Is this correct?
now if I specificly disallow g729 in the general context I can make calls to iaxtel. however i cannot make calls to server A as it only accepts g729. After I allow g729, I can make call to server A but the call made to iaxtel cannot go through.
The console indicates that the call is accepted by iaxtel using codec 729A, then it says the circuit is too busy.
Is there a clever way of governing the codec use for each outgoing connection in order to avoid the issue in codec negotiation?
-- David Kwok
Iaxtel/FWD # 17001813482 ext 1002
_______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
