Are you natted (behind a NAT screen)? Do you have any other SIP devices connected to the same network segment as your WiFi Access Point? Are they working correctly?
I would try turning off the canreinvite (set = 0) and, if there's a NAT between you and the Asterisk, turn on nat support (nat = yes). Good luck, Steve > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:asterisk-users- > [EMAIL PROTECTED] On Behalf Of Mark Phillips > Sent: Tuesday, March 16, 2004 3:04 PM > To: [EMAIL PROTECTED] > Subject: [Asterisk-Users] Anyone got their Pulver WiSIP phone working with > *? > > Hi Folks, > > Took delivery of 3 of these today and am having problems. Pulver tech > support is pretty much non existant so I came here. > > Problem is this. Phone configured to talk to * as extn 3405. * shows that > 3405 has registered and a sip show peers reveals its ip address etc. Make > a call from the WiSIP to any extension and * shows the call getting as far > as the native bridge. call fails after that point. If I let the VM pick up > * plays the VM messages and then hangs up. At no time does the WiSIP think > its connected. > > In the reverse direction, a call to the WiSIP gets dumped into VM straight > away. > > If I call the phone by its URI it rings but the calling phone never thinks > the call has been answered by the WiSIP. > > I have 711 as the codec and inband DTMF (which the WiSIP thinks should be > 2833). > > Any ideas ... > > Thanks > > > -- > Mark Phillips, G7LTT/KC2ENI > Randolph, NJ > http://www.g7ltt.com/ > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
